Convert 732.5210 into its octal equivalent.
To convert the decimal number \( 732.5210 \) into its octal (base-8) equivalent, we follow these steps: ### Step 1: Convert the Integer Part (732) to Octal We repeatedly divide the integer part by 8 and record the ______ __________ __________ _______ ____ _____ _________ ___ __________ ________.
_____ _________ __________ ___ ________ _____ ________ ________ ________ _____ _________ ___.
______ ____ _______ ______ ________.
________ _______ ___ ____ _____ ___ __________.
____ ____ _______ ______ ___ _______ ______ _____ ________ __________.
____ ____ _________ ______ _______ ______ ____ __________ ___ __________.
_________ ________ ____ ____ _____ _________ ____ ___ __________ __________ ___.
_______ ________ ___ ______ __________ ________ ___ _____ ____ ________ ________.
_________ __________ ______ _______ _________ ___ ___.
___ ________ _____ ___ ______ _____ _____.
_________ ____ ___ ____ ____ _______ _____ _______ ____.
_______ ______ ________ _________ _____ ________ ______ _________ _______ _________ ___ ___.
________ ________ _____ ________ _________ __________ ____ __________ __________ ___ _______.
___ ________ ______ _____ ______ ___.
____ _____ ______ ____ ________ ___.
_______ _________ _______ ____ ________.
_________ __________ _____ ____ ___.
_____ _________ __________ _____ ______ __________ _______ _____.
_______.
Get Full Answer on WhatsApp
Explain the different between a FET and MOSFET on the basis of their construction and working.
Convert 732.5210 into its octal equivalent.
State, with reasons, whether the following statements are True or False:
i) Kirchoff’s voltage law is valid only for passive element circuits.
ii) In a series resonant circuit, minimum current flows at resonance frequency.
iii) Higher form factor implies better rectification efficiency.
iv) Class A amplifier provides distortion free operation at the cost of efficiency.
v) LC oscillators are not preferred for generating low frequencies.
vi) Operational amplifier is the only type of amplifier available in IC form.
vii) In a regulator IC, the head room should be as large as possible.
viii)It is possible to build any gate using combination of only OR gates.
ix) D-latch uses edge triggering.
x) Mod-7 counter requires 4 flip-flops.
A triangular wave of V amplitude and 10 MHz frequency is generated at the output of an op-amp. Calculate the minimum slew rate of the op-amp used.
Design a zener regulator to give regulated 10 V dc output with maximum load current of 100 mA. Consider that input unregulated dc supply is 15 V and Write down the voltage and power ratings of the zener diode and power rating of series resistor Rs for your circuit.
Using superposition principle obtain the current flowing through load resistor in the circuit shown in Fig. 1.
Design a universal bias for a class-A CE-amplifier (Fig. 4.11c of your study material) using NPN transistor for the following parameter values: and
Obtain the values of
and